FFHdriver Report post Posted December 29, 2009 Has anyone done this? Saw a post that says it's a Torx adjustment screw. How do you get to the screw? One web site says, at 25 feet, the light pattern should be about an inch below the center of the bulb. I checked mine at 25 feet and the pattern didn't reach the wall. TIA. Quote Share this post Link to post Share on other sites
xmech2k Report post Posted December 29, 2009 If it's the same as the non-hybrids, run the front wheels up on some ramps, and you can access the torx screws through holes in the shield under the front bumper. I had to use an extension and a universal with some tape to keep it from flopping over. Quote Share this post Link to post Share on other sites
FFHdriver Report post Posted December 29, 2009 If it's the same as the non-hybrids, run the front wheels up on some ramps, and you can access the torx screws through holes in the shield under the front bumper. I had to use an extension and a universal with some tape to keep it from flopping over.Turn the screw counter clockwise to raise the lights? Quote Share this post Link to post Share on other sites
xmech2k Report post Posted December 29, 2009 Honestly, I forgot which way to adjust them. I just left the key to the on position and had them on while adjusting to see where the beam was. Sorry. :doh: Quote Share this post Link to post Share on other sites