smr2112 Report post Posted June 10, 2015 So on my 2013 Ford Fusion Hybrid Titanium - specifically with the stock TItanium/Hybrid wheels.... I decided I should check the lug torque and/or test my wrench and socket to see if I could getthe lug nuts off or tighten them. Well it is very hard on that car, with what I have anyway, tomove those lug nuts (I used a 17mm socket and have a 13/16" one too). Didn't have to applytoo much force to get them to strip just a bit. So ouch.... Could not do much, and the lugs rounded a bit before I quit so I hopefully did not do too muchdamage. I plan to order a full set of McGard chrome lugs (much better quality) and getthe dealer to replace them all. I have the Ford wheel locks on there already. I believe theMcGard part is 64012. Can somebody tell me the correct size of the lugs? I found McGard M12 x 1.5", but the sparelugs I measured seemed more like 1.25". The wheel lock specs say 1.50" and seem a bitlonger than the lugs. I think this may be partially why I had a hard time removing the existingones. Nut sure why I can't get a socket fully onto the lug. Works fine on the spare lugs offthe car. So I stripped them.... Size 1.5" will protrude just a bit like the wheel locks do now, but maybe this is good as it willbe easier to get off. Open to other brands if anybody has experience. Any suggestions /experience to remedy this? The stock lugs are close to flush with the rim. Rim is pretty much this one here: http://bit.ly/1KWwYqP Quote Share this post Link to post Share on other sites