SylviaTD Report post Posted July 13, 2018 Hi, my 2010 Fusion Hybrid with 99,000 miles has an ongoing problem with an alarm similar to the "stop when safe" (which I experienced once), but with no display message. The car has been in the shop twice now with a full tune up, master cylinder and control module replaced (after having a partial brake failure and having it towed) and the alarm still sounds. It can be within minutes of starting the car, but other days it will go hours without hearing it. I'm hoping it's just a glitch, but very wary.Any help would be appreciated. Quote Share this post Link to post Share on other sites
Automate Report post Posted July 19, 2018 (edited) Sounds like maybe the dealer has not upgraded the firmware to the latest version in all the computer modules. http://forscan.org with a OBD scanner is very helpful for troubleshooting. It even tells you if any of the modules do not have latest firmware. Edited July 19, 2018 by Automate Quote Share this post Link to post Share on other sites
frankf Report post Posted April 2, 2019 Sounds like maybe the dealer has not upgraded the firmware to the latest version in all the computer modules. http://forscan.org with a OBD scanner is very helpful for troubleshooting. It even tells you if any of the modules do not have latest firmware.do you know where to find the spreadsheet for the 2010-2012 fusion hybrid? Quote Share this post Link to post Share on other sites
Automate Report post Posted April 2, 2019 do you know where to find the spreadsheet for the 2010-2012 fusion hybrid? I assume you mean for as-built / configuration? I have not come across one. What in particular are you looking to enable / disable? Quote Share this post Link to post Share on other sites
frankf Report post Posted April 3, 2019 I assume you mean for as-built / configuration? I have not come across one. What in particular are you looking to enable / disable?I was trying to see about doing the digital speedometer and the dark car mode. I'm not even sure exactly what I can do. Quote Share this post Link to post Share on other sites
Automate Report post Posted April 3, 2019 Most of the lighting control (such as dark car) is controlled by the GEM / SJB (also called BCM on some Fords). The Fusion Hybrid configuration of this module should be similar to other Fords of similar model year. The IPC module controls the instrument panel I have not seen anyone turn on a digital speedometer. This IPC module is only used in the 2010-2012 Fusion Hybrid, Lincoln MKZ Hybrid and Mercury Milan Hybrid so the IPC configuration will be different from all other Ford cars. Some people just start changing some of the values and see what happens. Kind of trial and error. Quote Share this post Link to post Share on other sites
girney Report post Posted September 18, 2019 we had an alarm go off sporadically with no error codes or message. turned out to be the water pump for the hybrid system. even dealer didnt know what to do till i showed him a printout of someone else on forum with same problem Quote Share this post Link to post Share on other sites
