Jump to content
Fordfusiontitaniumenergi

Finally I have a space saver spare tire for my Energi!

Recommended Posts

I bought the space saver spare combo previously listed for the FFH thinking it would fit my Energi. I did not see the pin about it not fitting until to late. I purchased the 2012 Ford focus rim (80.00) and the Continental 16" space saver tire (40.00) from a Altima on eBay. I realized the rim just clipped the rear caliper base. So I ground down the scratched area on the caliper about a 16th, and now the rim mounts on the rear with no issues.

I have the space saver rim and tire in my trunk, a Ford windstar jack as listed also, and a jack stand.

The plan is to only have the right rear caliper as the space saver side. I now can jack up any flat tire on any side front or back, put the jack stand underneath, remove the right rear rim, install that on the front or back flat side and put the space saver on the adjusted caliper side.

I took a 3 hour ride today knowing I had a spare and tools in my tiny trunk.

The Continental tire is the same height as my Factory 17" tire. Now by putting the spare on the rear there's no worry about front end pulling.

No lectures on removing a 16th of metal in an 1/2" area please. Just trying to help others.

Oh, sorry. Hi, new member here on this wonderful site. Thanks so much to "GrySql" that did all the research on a space saver for the FFH.

Some people say they never get a flat. I got 3 flats in 3 months.

 

Link to original thread about which rim and tire to use for the FFH.

http://fordfusionhybridforum.com/topic/6818-spare-tire-for-ffh-with-18-wheelstires/

post-12782-0-92908400-1407538979_thumb.jpg

post-12782-0-16083200-1407538994_thumb.jpg

post-12782-0-74917600-1407539001_thumb.jpg

post-12782-0-89416300-1407543953_thumb.jpg

Edited by Fordfusiontitaniumenergi

Share this post


Link to post
Share on other sites

My wife came up with a neat way to store the tire with a bungy cord. We also wrapped up the jack,jack stand and crank in towels and stuffed them on the top shelf behind the tire. It's all good. If our 45,000 car gets a flat it won't take 6 hours to get it back on the road like last time.

post-12782-0-44929300-1407616380_thumb.jpg

Share this post


Link to post
Share on other sites

You say you've had 3 flats so far, what brand tire are your OEM's?

Edited by GrySql

Share this post


Link to post
Share on other sites

Oem Mitchelin X Green 17" Not the tires fault.
Bad luck. 1st time my wife hit a pot hole that tore the side wall. That was the 6 hour day.
2nd time a screw in my garage punched a hole that caused a slow leak. That tire I plugged while on the car but used a old rubberized plug that came out 3 days later while she was in a shopping plaza. I had her turn the front wheel outward while I put in a larger leather plug.
Yesterday I had that removed and had iti internally patched.

Edited by Fordfusiontitaniumenergi

Share this post


Link to post
Share on other sites

You should have pulled that caliper, ground it smooth and polished it! :) J/K Glad you found a way to make it work.

Share this post


Link to post
Share on other sites

Do you think the spare would clear the rear caliper if you used a 5mm spacer between the hub and rim? Since you had to remove so little material it seems like it might work that way, too.

Share this post


Link to post
Share on other sites

Do you think the spare would clear the rear caliper if you used a 5mm spacer between the hub and rim? Since you had to remove so little material it seems like it might work that way, too.

Thanks for your idea. I did try spacing it out. It wouldn't work because the rub is deep in the rim. Pulling the rim outward only moves the rub outward with at least 6 more inches to go. No regret grinding down the caliper outside area. I drive with confidence having that spare there plus it's high up in the well so we still use the area for food bags etc.....

Share this post


Link to post
Share on other sites

Fordfusiontitaniumenergi, can you provide part numbers for the wheel and exact tire size. I will be picking up our 2015 Fusion Energi this week and want a spare.

Share this post


Link to post
Share on other sites

Fordfusiontitaniumenergi, can you provide part numbers for the wheel and exact tire size. I will be picking up our 2015 Fusion Energi this week and want a spare.

I listed the original thread with all that info in the first part.

click here. 2012 focus rim via ebay, Nissan tire, size listed on thread. You have to trim caliper. Read entire thread.

 

http://fordfusionhybridforum.com/topic/6818-spare-tire-for-ffh-with-18-wheelstires/

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...