LED DRL Project 03 Threading Wires
We threaded the wires for the LED strip between the lens and the front molding. There is a slight gap at the corner of the lens but it required gently lifting the molding slightly to slip the wires in place. To add a little extra protection to the wires against chaffing, we wrapped the wiring in a layer of electrical tape. When wiring the LED strips, several inches of slack was left for each LED strip so that the headlights could be changed when it becomes necessary.
Copyright
© Ken Barbalace
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.